The paint stripping method of aluminum Enameled Wire is to use paint stripper. This product is believed to have been used by many people. I also believe that many people have long been unable to bear the paint stripping efficiency. In about one minute, you have to wait for the line of 150. You have to wait for the line of 180. Wait for the line of 220. You should wait for the aluminum line. Small, in general, it is a good idea to use paint stripping to remove paint. Many factories make special molds.
A large number of aluminum enameled wires dipped in paint remover are placed on fixed shelves and wait for paint remover reaction. The efficiency can also be . But for the high temperature line, the stripping of various manufacturers is basically useless, no matter how much time the paint will not be removed, so this method is not suitable for the high temperature line. In addition, by the way, the paint remover is generally alkaline. The metal of aluminum is an amphoteric metal, the acid can corrode it, and the alkali can also be used. Therefore, the friend who is currently using the paint remover is used after you take off the paint. Be sure to rinse with water (or alcohol) (preferably use ultra-wave cleaner), paint remover is more soluble in water or alcohol, just drift a little, be careful that your solder joint is corroded by paint remover.
The paint method is not suitable for most motor manufacturers because the diameter of the aluminum enameled wire used by motor manufacturers is relatively small. In addition, the centrifugal knife will peel off the aluminum wire during the stripping process. The diameter of the aluminum enameled wire will generally become smaller or more than a few dozen wires or more. This method may not be used for customers with higher requirements.