News

XINYU ELECTRICAL

News

  • What is the Best Way to Wrap Enameled Copper Wire

    I think should use a drill, preferably a cordless screwdriver / drill because they are quite slow and you can vary the speed.Put it to a drill that has a very slow rotation setting,then the rest is simple ! Put a small mark on the chuck with tape or paint so you can count the revolutions, if you nee...

    26-12-2017
  • What is Enameled Copper Wire

    If you want to make a coil to make a motor, If you know nothing about this, xinyu could give the answer for you. Copper wire with a coating of enamel to insulate it. It's intended to be used in coils and transformers where the wire is wound with the turns in physical contact with each other. the ena...

    25-12-2017
  • Annealing Process of Enamelled Wire

    The purpose of the annealing is to make the conductor harden due to the lattice changes during the stretching process of the mold and heat it to a certain temperature so as to restore the softness required by the process after rearrangement of the molecular lattices and to remove the residual conduc...

    22-12-2017
  • How can I Determine the Dielectric Strength of Enamelled Wire

    As an extension of my previous inquiry into air-core chokes, I'm trying to determine the voltage insulation rating of enamelled wire, without much luck. Few of the audio air-core choke manufacturers list that data, and none of the enamelled wire manufacturers I've checked give it either. How can I b...

    21-12-2017
  • First Payed Off of Enamelled Wire

    In a normal operation of the enamelled wire charter, the operator's energy and physical strength are mostly consumed in the pay-off part of the exchange of pay-off disk so that the operator to pay a lot of labor, when changing the line prone to quality problems and operational problems. The effectiv...

    20-12-2017
<<...102030...8081828384...90...>>