Global News

Precautions During the Winding Process of Enameled Copper Wire

Update:21-08-2018
Summary:

(1). The winding method is strictly carried out accordi […]

(1). The winding method is strictly carried out according to the requirements of the drawings. If it is arranged, the enameled wire should be arranged regularly. There should be no unevenness, looseness, crossover and knotting. If there is a winding, the enamelled wire should be kept at a certain interval. .

(2). Winding winding sequence, number of turns, slot in and out of the foot is strictly implemented according to the technical requirements, not in the order of inversion, multi-turn and small circle, into the wrong foot slot; the incoming and outgoing lines should be 90° right angle, not inclined Pulling; when winding the error, the wire pack needs to be taken off and retracted, and the winding machine reset is wound from the head.

(3). If there is a retaining wall in the wire package, the enameled wire will not wrap around the retaining wall.

(4). It is strictly forbidden to use the scissors and nails to push the coil to damage the patent leather; if the winding process is concerned, please pay attention to whether the enameled wire has peeling paint, blackening, scratching, etc. If found, stop using the wire and quickly stretch it. Perform a mass response.

(5). The lead wire needs to be padded with a layer of tape. The tape should be placed in the center of the enameled wire and the winding, and it should be firmly attached and positively attached.

(6). If the casing is required to be loaded at the beginning, the length of the casing extending into the wire package shall be greater than 3 mm, and the length of the extended casing shall be flush with the bottom of the frame of the frame or slightly higher than the plane of the bottom of the pin.

(7). In order to prevent the waste of the enameled wire, the length of the starting line should be 183 mm.

(8). In the winding, it is required to add shielding tape. The shielding tape should be placed in the center of the Enameled Copper Wire trough, and pay attention to the insulation at both ends. The starting and ending ends should not be in contact with the short circuit.